 |
| This is the leftover piece from my rear fender but it was too wide so I cut the sides off of it. |
 |
| Then used my cheapo Princess Auto bead roller to put a bead in the edge. I would rather have a curved 90 degree edge but couldn't figure out the dies that came with the roller. |
 |
| And the finished fender |
 |
| I cut all the unnecessary mounts off the top of the frame |
 |
| Then welded the seat hinge in place |
 |
| I made a new intake manifold so I could mount this Keihin carb |
No comments:
Post a Comment